共找到 164 條與 液體介質與植物、動物、人體器官采樣方法 相關的標準,共 11 頁
本標準規定了地下水資源分類分級的原則以及類別和級別的名稱、定義、劃分條件、用途和代號。 本標準適用于地下水資源各個勘查階段,是各個勘查階段設計書編制、工作部署、地下水資源量計算、報告編寫的重要依據,也是地下水資源量審批、統計;水源地立項、設計,制定地下水開采計劃、規劃的重要依據。
Standards of classification for groundwater resources
本標準規定了湖泊和水庫采樣方案設計、采樣技術、樣品保存和處理的詳細原則。 本標準不包括微生物檢驗的采樣。 本標準適用于湖泊和水庫。其主要目的有以下二種: 水質特性檢測 水體長期的質量檢測。用于調查研究湖庫水質狀況及發展趨勢。 水質控制檢測 在水體中一個或幾個指定的采樣點進行長期水質檢測。 特殊情況的檢測 當有生物種類或種群發生障礙、死亡或其他異?,F(xiàn)象(水華、顏色等)出現時對污染的鑒定和測定。
Water quality. Guidance on sampling techniques from lakes, natural and man-made
本標準適用于天然水、生活污水及工業廢水等,當所采集的水樣(瞬時樣或混合樣)不能立即在現場分析,必須送往實驗室測試時,本標準所提供的樣品保存技術與管理程序是適用的。
Water quality sampling--Technical regulation of the preservation and handling of samples
Water Quality Sampling Technical Guidance
本標準是采樣技術的基本原則指導,不包括詳細的采樣步驟。 本標準適用于開闊河流、封閉管道、開闊水體、底部沉積物及地下水采樣。 本標準是為質量保證控制、水質特征分析、底部沉積物及污泥在內的采樣技術指導,是為水污染鑒別得到可靠的數據而設計的。
Water quality--Guidance on sampling techniques
Technical regulations on storage and management of water quality sampling samples
本標準規定了水(包括底部沉積物和污泥)的質量控制、質量表征、污染物鑒別采樣方案的原則。
Water quility--Technical regulation on the design of sampling programmes
Characterization of sludges. Physical consistency. Determination of flowability. Method by extrusion tube apparatus
Testing of chemicals of environmental hazard. Fish embryo acute toxicity (FET) test
Testing of chemicals of environmental hazard. Honey bee (Apis mellifera) larval toxicity test, single exposure
Testing of chemicals of environmental hazard. Determination of pH, Acidity and Alkalinity
Characterization of waste - Leaching behaviour test for basic characterization - Dynamic monolithic leaching test with periodic leachant renewal, under fixed conditions; German version EN 15863:2015
This European Standard is applicable for determining the leaching behaviour of monolithic wastes under dynamic conditions. The test is performed under fixed experimental conditions in this document. This test is aimed at determining the release as a function of time of inorganic constituents from a monolithic waste, when it is put into contact with an aqueous solution (leachant). This dynamic monolithic leaching test (DMLT) is a parameter specific test as specified in EN 12920 and is therefore not aimed at simulating real situations. The application of this test method alone is not sufficient for the determination of the detailed leaching behaviour of a monolithic waste under specified conditions. In the framework of EN 12920 and in combination with additional chemical information, the test results are used to identify the leaching mechanisms and their relative importance. The intrinsic properties can be used to predict the release of constituents at a given time frame, in order to assess the leaching behaviour of monolithic waste materials, placed in different situations or scenarios (including disposal and recycling scenarios). The test method applies to regularly shaped test portions of monolithic wastes with minimum dimensions of 40 mm in all directions that are assumed to maintain their integrity over a time frame relevant for the considered scenario. The test method applies to test portions for which the geometric surface area can be determined with the help of simple geometric equations. The test method applies to low permeable monolithic materials. Within the reproducibility ranges, the leaching results obtained with EN 15863 are expected to be equivalent to those obtained with CEN/TS 16637-2 (DMLT for construction products), because the main testing conditions are equalized in both standards. As shown in the results obtained with EN 15863, they are also demonstrated to be comparable with US EPA method 1315 (SW846).
Characterization of waste - Leaching behaviour test for basic characterization - Dynamic monolithic leaching test with periodic leachant renewal@ under fixed conditions
Testing of chemicals of environmental hazard. Determination of the solution/extraction behaviour of polymers in water
Testing of chemicals of environmental hazard. Determination of the particle size distribution/determination of the fibre length and diameter distribution. Method A: Particle size distribution (effective hydrodynamic radius). Method B: Fibre length and dia
Testing of chemicals of environmental hazard. Determination of the low molecular weight content of a polymer using gel permeation chromatography
Testing of chemicals of environmental hazard. Determination of the UV-VIS absorption spectral by spectrophotometric method
Testing of chemicals of environmental hazard. Determination of the Number-Average Molecular Weight and the Molecular Weight Distribution of Polymers using Gel Permeation Chromatography
Testing of chemicals of environmental hazard. Determination of the melting point/melting range
Testing of chemicals of environmental hazard. Determination of the liquid viscosity
Copyright ?2007-2025 ANTPEDIA, All Rights Reserved
京ICP備07018254號 京公網安備1101085018 電信與信息服務業務經營許可證:京ICP證110310號
頁面更新時間: 2025-02-05 11:48